Variable Controllers VHC-15
Solid state variable device controls heat loads up to 15-Amps
120/208/240Volt “In-Line” Controller
Built in On/Off knob switch with positive “off” & surface plate included
Designed for a 2” x 4” electrical wall box mounting (not supplied)
Must be mounted in a protected area.
Can only operate Fostoria Quartz Tube Infrared Heaters
California residents see Prop 65 Warnings
Catalog Number Model Number Width Height Depth Weight 04459402 VHC-15 5 5 3 3
Variable Controllers VHC-32
Solid State phase angle variable “Triac” knob controller adjusts heat settings from 10-100% with heat loads up to 15.4-Amps
208/240 VAC single-phase, single stage controller, 3200 Watt max
Positive “Off” & built-in On/ Off Rocker switch lights “red” during operation
NEMA 1 Aluminum enclosure with stainless steel face plate designed for wall mounting or suitable for semi-recessed applications
Must be mounted in a protected area.
Can either operate Quartz Lamps or Quartz Tube Infrared Heaters
California residents see Prop 65 Warnings
Catalog Number Model Number Width Height Depth Weight 04853502 VHC-32 5 5 3 3
Variable Controllers VHC-66 & VHC-99
VHC-66 & VHC-99 SCR variable voltage controller w/ potentiometer
Potentiometer can be mounted on enclosure or remotely in a 2×4 electrical wall box (not supplied)
Can be used on all Fostoria infrared 208/240V single phase products; with heat load up to 48-amps
Soft start operation to avoid high amperage inrush current on circuits
NEMA 1 Aluminized or Gray powder coated epoxy finish enclosure
Customized color options are available
California residents see Prop 65 Warnings
Catalog Number Model Number Width Height Depth Weight 04924602 VHC-66 10 10 6 9 04924702 VHC-66-P 10 10 6 9 04924802 VHC-99 10 10 6 9 04924902 VHC-99-P 10 10 6 9
SCR Controller 18D
SCR Voltage Controller – 80 Amp MAX.
Includes (1) 24-volt Potentiometer (3” square) to control the heat output
Only operates Quartz Lamps at 240 or 208-Volts, single phase only
Potentiometer can be mounted outside, but the SCR must be located in a protected area
Factory wired with millisecond fuses included
California residents see Prop 65 Warnings
Catalog Number Model Number Width Height Depth Weight 04456302 18D-2-30CF 6 9 6 11 04456402 18D-2-30CF 10 12 8 15 04456502 18D-2-80CF 12 14 8 29 04459502 FTC-30 5 5 2 3
Snow & Ice Detectors
Main control unit for Automatic Snow & Ice Control Systems
By sensing both temperature and moisture the system activates and melts any snow & ice accumulations until conditions subside
NEMA 3R Enclosure is UL Listed and houses timers and switching electronics to operate the system
Capability to monitor up to 6 sensors (CIT-1)
Unit can be manually activated and can be controlled and monitored from an optional remote switch (Model RCU- contact factory)
Positioned above ground to maximize the sensors capability
Detects falling or blowing of precipitation such as snow when the temperature is below 38°F
Most common sensor device
California residents see Prop 65 Warnings
Catalog Number Model Number Width Height Depth Weight 03196100 APS-3C 11.5 9.25 6.56 8 03197600 CIT-1 3.25 4.13 3.25 1
Contactor Enclosures FEC
Economical load handling / switch device, ideal for use with other control equipment
NEMA 1 Enclosures
Load rating up to 600V Max., 3-Pole
Magnetic contactor
California residents see Prop 65 Warnings
Catalog Number Model Number Contractor Amp Coil Volt Depth Weight 04408502 FEC-30-120 30 120 5 5 04408602 FEC-30-240 30 208/240 5 5 04408702 FEC-60-120 60 120 5 5 04408802 FEC-60-240 60 208/240 5 5
Installer to provide overload protection for all infrared heaters
Control Panels FPC Series
ONE HEATER PER CIRCUIT
Max 48-Amps per circuit*
Step-down transformer for 24V or 120V control circuit
Secondary control circuit fusing
3-Phase load rated
NEMA 1 Enclosures
The following controls are available: Snow and Ice Detector (APS-3C) (120 volt control required), Single and Two-Stage Thermostats (Two-Stage Thermostats require a minimum of 2 circuits)
California residents see Prop 65 Warnings
FPC Series Standard Control Panel Models – 120 Volt Control System
Catalog Number Model Number Circuits Voltage Depth Weight (lbs) 04459902 FPC8110 1 208 6.75 52 04460002 FPC2110 1 240 6.75 52 04460102 FPC7110 1 277/480 6.75 52 04460202 FPC4110 1 480 6.75 52 04460302 FPC8120 2 208 6.75 70 04460402 FPC2120 2 240 6.75 70 04460502 FPC7120 2 277/480 6.75 70 04460602 FPC4120 2 480 6.75 70 04460702 FPC8140 4 208 6.75 88 04460802 FPC2140 4 240 6.75 88 04460902 FPC7140 4 277/480 6.75 88 04461002 FPC4140 4 480 6.75 88 04461102 FPC8160 6 208 6.75 106 04461202 FPC2160 6 240 6.75 106 04461302 FPC7160 6 277/480 6.75 106 04461402 FPC4160 6 480 6.75 106
FPC Series Standard Control Panel Models – 24 Volt Control System
Catalog Number Model Number Circuits Voltage Depth Weight (lbs) 04864302 FPC8210 1 208 6.75 52 04864402 FPC2210 1 240 6.75 52 04864502 FPC7210 1 277/480 6.75 52 04864602 FPC4210 1 480 6.75 52 04864702 FPC8220 2 208 6.75 70 04864802 FPC2220 2 240 6.75 70 04864902 FPC7220 2 277/480 6.75 70 04865002 FPC4220 2 480 6.75 70 04865102 FPC8240 4 208 6.75 88 04865202 FPC2240 4 240 6.75 88 04865302 FPC7240 4 277/480 6.75 88 04865402 FPC4240 4 480 6.75 88 04865502 FPC8260 6 208 6.75 106 04865602 FPC2260 6 240 6.75 106 04865702 FPC7260 6 277/480 6.75 106 04865802 FPC4260 6 480 6.75 106
Fusing Information
Fuses are NOT included since panels can be used with various infrared heat sources.
Quartz Lamp Heat Sources: Use FRS-600V (or equal) “Time Delay” fuses; Class RK-5.
Quartz Tube & Flat Panel Emitter Heat Sources: Use KTS-R 600V (or equal)
“Fast Acting” fuses; Class RK-1.
*Circuit fusing less than 35 Amps will require the use of fuse reducers – Not included
Contact Us For A Custom Quote
PE Energy is an authorized TPI Corporation distributor
Request a Quote
See all TPI Corporation products
